Beverage Fountain

Download the PDF Instructions

Please read these instructions carefully before use

Operation

• Pour approximately two quarts of beverage in lower reservoir and turn switch to ON position until pump is activated.
• If beverage does not circulate within one minute, turn switch to OFF for 10 seconds.
• Repeat this procedure several times until beverage flows freely. If this procedure fails, pour beverage in top reservoir, with switch in ON position until pump is activated.

Cleaning Instructions

After use, empty out remaining beverage and fill lower reservoir with two gallons of warm water and let circulate for five minutes. Empty the unit and repeat again. DO NOT use scouring pads or any type of abrasive for cleaning. DO NOT take unit apart.

Helpful Hints

-To chill a beverage, use chunks of ice in the bowl, ice cubes in a plastic bag or several pieces of dry ice in the bowl.
-Precool beverage whenever possible to at least 36 degrees before adding to fountain.
-When using carbonated beverages pre-chill to at least 36 degrees before adding to fountain. To avoid dilution, place bags of ice enclosed in plastic in the fountain. Carbonation will dissipate after 10 to 20 minutes of recirculating in the fountain, so it is advisable to add smaller quantities of mixtures to the fountain from time to time to maintain carbonation.
-Beverage fountains are designed to circulate clear beverages. Use of beverages with pulp, seeds, fruit, rinds, etc. will restrict the flow of the beverage and may give unsatisfactory results. Use of ice cream or other foamy punches may also restrict the flow of the beverage.
-DO NOT run fountain dry.
-DO NOT immerse base of fountain in water.